Chief PXRUB Instalační manuál stáhnout pdf (Strana 11)

Installation Instructions PXR

8. Mark the pilot holes through PXR upper bracket. (See

Figure 7)

9. Carefully remove the PXR from the mounting bracket.

10. Drill two 7/32" x 2-3/4" (5.5mm x 69.9mm) pilot holes at

locations marked in Step 9.

11. Return PXR to mounting bracket and fasten to wall using

two 5/16 x 2-1/2" lag screws (RC) and two 5/16" flat

washers (RB). (See Figure 7)

Figure 7

12. Remove two orange Velcro® straps holding PXR arms in

place. (See Figure 8)

Figure 8

13. Connect and route power cord (Z) through PXR cable

management areas. (See Figure 9)

Figure 9

IMPORTANT ! : Do not power the PXR until it is ready to

be tested.

x 2

(RC) x 2

(RB) x 2

Strap locations

(Z)

NOTE: Proceed to Arm Engagement section.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Žádné komentáře

Chief PXRUB Instalační manuál Strana 11