Chief RPMA084 Specifikace stáhnout pdf (Strana 10)

RPA Elite Series Projector Mount Installation Instructions

PROJECTOR INSTALLATION

IMPORTANT ! : Model RPM uses Chief "SLB"

Series interface brackets and Models RPMA,

RPMB and RPMC use Chief "SLM" Series

interface brackets.

Install Interface Bracket

NOTE: If a model RPMA, RPMB, or RPMC is being

installed, the interface bracket will be shipped

with thumb nuts attached and locked into place.

If this is the case proceed to Step 2a. Both the

interface bracket and amount of hardware will

vary dependent on projector model.

1. Partially thread thumb nuts onto Phillips flat head

screws until screw end is visible in top of thumb

screw.

IMPORTANT ! : DO NOT fully tighten thumb

screws at this time.

Threaded Rod Installation

The RPM can be secured to unistrut, angle or channel

assembly overhead structural members (trusses or I-

beams) using four 1/4” diameter threaded rods.

WARNING: IMPROPER INSTALLATION CAN

RESULT IN SERIOUS PERSONAL INJURY OR

DAMAGE TO EQUIPMENT! Structural members

MUST be capable of supporting five times the

combined weight of all equipment being mounted.

1. Carefully determine required mount position.

IMPORTANT ! : This will require knowing the lens

to screen distance. See projector specifications

for determining this distance.

NOTE: Threaded rod and installation hardware not

included.

2. Secure one end of the threaded rod to the structural

member.

3. Install four 1/4-20 jam nuts on each threaded rod.

4. Install the RPM on the threaded rod.

NOTE: Hole in the RPM allows socket wrench access

without unit disassembly.

5. Secure the RPM to the threaded rod using four

1/4-20 nuts.

(A)

1 2

X 4

Example Only

(Interface bracket

varies dependent

on projector model)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Komentáře k této Příručce

Žádné komentáře

Chief RPMA084 Specifikace Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Připojení projektoru Chief RPMA084