Chief WBM2 Instalační manuál stáhnout pdf (Strana 7)

Installation Instructions WBM2

Using a level, mark the wall above existing chalkboard

through top mounting hole in the wall assembly (K).

(See

Figure 3)

Figure 3

3. Drill one 1/4" x 2-3/4" pilot hole at each marking. (See

Figure 3)

4. Install a toggler (B) into both pilot holes using a hammer.

(See Figure 3)

5. Use two 1/4-20 x 2-1/2" lag bolts (C) and two 1/4" flat

washers (A) to attach wall assembly (K) to anchors in wall.

(See Figure 3)

6. Mark the wall through the lower mounting hole in the wall

assembly (K). (See Figure 3)

7. Drill one 1/4" x 2-3/4" pilot hole at each marking through

lower mounting hole in wall assembly (K). (See Figure 3)

8. Install a toggler (B) into both pilot holes using a hammer.

(See Figure 3)

Use two 1/4-20 x 2-1/2" lag bolts (C) and two 1/4" flat

washers (A) to attach wall assembly (K) to anchors in wall.

(See Figure 3)

Attaching Interactive Whiteboard

1. Attach upright assembly (D) to back of white board using

four 1/4-20 x 1" Phillips pan head screws (H), four isolation

washers (G) and four .500"x.320"x.425" spacers (J). (See

Figure 4)

2. Repeat for second upright assembly. (See Figure 4)

Figure 4

Attaching Uprights to Wall Extrusion

1. Hook whiteboard with attached uprights onto the wall

asssembly (K). (See Figure 5)

2. Move the slide nut so that it is aligned with the upright (D).

(See Figure 5)

3. Fasten upright in place using one 1/4-20 x 3/8" button head

cap screw (F) and one .4"x.255"x.0625" nylon spacer (S).

(See Figure 5)

4. Repeat for other side of wall extrusion.

Figure 5

(B) x 4

(A) x 4

(K)

(D) x 2

Interactive

white board

(J) x 4

(H) x 4

(G) x 4

(D)

(F) x 1

(Interactive

board not

shown)

(K)

(S) x 1

Slide nut

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Chief WBM2 Instalační manuál Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Montážní sady Chief WBM2