Chief WBM2 Instalační manuál stáhnout pdf (Strana 8)

WBM2 Installation Instructions

Adjustments

Lateral Movement

1. Loosen one button head cap screw at top of upright

assembly (D). (See Figure 6)

2. Slide upright assembly left or right on wall assembly (K), as

necessary. (See Figure 6)

3. Tighten button head cap screw to fasten upright assembly

into place. (See Figure 6)

Figure 6

Vertical Adjustment

1. Loosen one button head cap screw with spacer at top of

each upright assembly (D). (See Figure 7)

2. Unhook whiteboard from wall assembly (K). (See Figure 7)

Figure 7

3. Loosen four Phillips head screws on back of white board.

(See Figure 8)

4. Adjust white board up or down, as required. (See Figure 8)

5. Tighten four Phillips head screws (H) into four isolation

washers (G) and spacers (J) to fasten white board to upright

assembly (D). (See Figure 8)

Figure 8

6. Hook whiteboard with attached uprights onto the wall

assembly (K). (See Figure 7)

7. Tighten button head cap screw with spacer (loosened in

Step 1) at top of each upright assembly to fasten upright

assemblies (D) into place. (See Figure 7)

Micro Height Adjust and Leveling

1. The wall assembly (K) can be adjusted or leveled by turning

the hex head bolt in the brackets. (See Figure 9)

• Turn clockwise to raise wall assembly

• Turn counterclockwise to lower wall assembly.

Figure 9

(D)

(K)

x 1

1 7

x 2

Sliding nut

(K)

(Interactive

board not

shown)

(D)

3 5

(H) x 4

(G)

(J)

(D)

(K)

(Interactive

board not

shown)

LOWER

RAISE

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Chief WBM2 Instalační manuál Strana 8

Komentáře k této Příručce

Související produkty a manuály pro Montážní sady Chief WBM2